Capacitive Sensors
Elite Series Capacitive Sensors and Systems 
- Highest Performance
- 1 to 8 Sensing Channels
- Available Modules Include:
- 1-, 2-, 3-, 6-, and 8-Slot Options
for LabVIEW™ - Probes can be ordered as vacuum compatible.
Elite Series sensors provide the flexibility of custom configurations for specific applications and out-of-the-box usability.
Life-Cycle Status: Active
Elite Series Modules and Enclosures:
Capacitive Sensor Driver Modules
CPL Series capacitive sensor modules are our highest performing sensor. Resolutions can be as low as subnanometer. A front panel range indicator and coarse and fine zero adjustments make them easy to set up.
The CPL190 is calibrated for a single range with one probe.
The CPL290 is calibrated for two ranges from a single probe or from two different probes for the ultimate in flexibility.
Display/Peak Capture
The MM190 is a combination signal processor, peak capture, and display module. Any two channels can be combined mathematically, peaks can be captured and held, and sensor output can displayed in inch or metric units. A front panel BNC connector carries an analog voltage that is proportional to the displayed value.
Temperature Sensors
The TMP190 sensor module can monitor up to seven channels of sensor data. This module is designed as part of our Spindle Error Analyzer and is not intended to be used apart from it. But the module can be programmed and read through National Instruments Data Acquisition hardware. Sensor connector information is included in the manual for those wanting to access the temperature sensors apart from our SEA system.
TMP190 Temperature Sensor Module
Intelligent Enclosures
Elite Series modular enclosures are available in 1-, 2-, 3-, 6-, and 8-slot versions. The intelligent enclosures provide power, synchronization, data acquisition, and other control signals to the modules.
Elite Series enclosures provide a 64-pin rear panel connector for easy direct connection to National Instruments data acquisition hardware.

